A mouthpiece for dental diagnosis and treatment

2024年6月18日

Orthodontic opener is a device that supports the oral cavity through its wings, isolates oral mucosal tissue from dental tissue, and

provides a good field of view and working area; A suction device is a device that uses negative pressure to remove cooling water,

saliva, blood, and other substances from dental phones during oral treatment. Therefore, orthodontic mouthpiece and suction devices

are important auxiliary tools for oral diagnosis and treatment operations.

The four handed technique is a commonly used mode of oral treatment, but due to the diversity of nurse operations, it is difficult to

attract in a timely manner, which can easily cause patients to swallow, cough, and contaminate the operating area. And due to the gap

in medical and health care, the four handed operation mode has not been fully popularized. When doctors operate independently,

they not only need to complete routine treatment but also need to perform suction and other diagnostic and therapeutic operations,

which seriously affects the efficiency and quality of diagnosis and treatment.

In response to the problem of busy medical treatment operations in oral clinics that cannot be effectively attracted in a timely manner,

the opening device will be improved to increase its attraction function. This product is not only clinically convenient to operate. It can

also improve the efficiency and quality of diagnosis and treatment for liberating the hands of medical staff.

Including attractors, connecting handles, external joints, and side walls. There is one suction device on each side, which is cylindrical

and has a wrinkled body. The length can be adjusted within a range of 2-4cm. The head is duckbill shaped and slightly tilted to the

cheek side, providing suction. The connecting handle is highly elastic, with a flat cavity, and the left and right ends are connected to

the suction device. The external connector will be connected to the suction device on the dental comprehensive treatment chair. The

lateral wall has a U-shaped structure on each side that is consistent with the patient’s mouth angle and serves as a support. This

product is made of low-density polyethylene material, with high elasticity, high mouth fit, convenient use, and comfortable wearing.

Squeeze the left and right side walls of the new orthodontic suction opening device towards the middle, making the opening device

smaller and placed on the patient’s lips and cheeks, supporting the mouthpiece muscles of the patient’s lips and cheeks, and providing a good view

for the doctor. Adjust the length of the suction tubes on both sides and place them slightly towards the buccal side of the patient’s

molars. Connect the suction connector on the dental chair to the mouthpiece external connector to suck out contaminated liquid from the patient’s

mouth.